![]() ![]() Quick release brackets can be supplied - allowing the clamp to be mounted/dismounted quickly without any tool. This extremely robust sliding profile improves gliding and reduces wear and tear. If required, clamps can be fitted with valveblock sideshift (VBSS), which uses the residual stroke of the clamp cylinders to achieve lateral arm movement.Ī replaceable wear bar comes standard and allows the tip of the attachment pads to clamp the load with suitable pressure.Ī combination of T and C profiles is used on OEA Kaup Clamps, providing high stability. All sideshift housings features end-of-stroke- slow-down (Softstop). Independent sideshift system permits sideshifting without restriction under safety regulations and allows utilization of the entire opening range for shifting loads sideways. Once the hydraulic lines from the attachment to the truck are connected the attachment is ready for operation. Attachments with capacities above 3.5 tons feature tandem rollers. These are needle bearing guided bottom brackets (Smoothroll). The complete attachment is mounted onto this guide rail and secured by bolting the bottom mounting brackets to the carriage. The guide rail for the sideshifter housing is located on the upper bar of the fork carriage and locks into the center notch. Spent batteries are a hazardous waste unless they are properly reclaimed at a lead smelter or battery recycler.All dimensional sizes are nominal.Recycle or properly dispose of batteries.Warning signs of a low battery include slow starting, dim headlights, and the ammeter indicating discharge at high RPM.This can result in permanent battery damage and shorten battery life considerably. ![]() Avoid discharging batteries beyond the manufacturer’s discharge level.Do not over charge or under charge batteries.Do not exceed the service hours in the manufacturer’s recommendations.Do not continue a battery in service merely because it continues to deliver power.Battery failure could lead to mechanical breakdowns and possible accidents involving forklift operators and/or other personnel. Implementing a proper battery maintenance program can increase the life of the batteries and help protect employees. Under normal operating conditions, power industrial truck forklift batteries can be expected to remain in service for 2,000 work shifts or charge/discharge cycles. Check the indicator on the hour meter to see that battery is fully charged.Return battery to forklift with lifting beam and secure in place after charging.Add distilled water or de-ionized water if water level is below level indicator. Restart charging at a lower charging rate.Ĭheck water level after charging. Turn off the charger if the battery becomes hot or the electrolyte fluid comes out of the vents.Unplug and turn off the charger before connecting or disconnecting the clamp connections.If the battery has sealed vents, do not recharge with a current greater than 25 amperes. Record the specific gravity with the hydrometer in the service log. Check the electrolyte level before recharging. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |